We haven't had anyone complain about the finish coming off on the Ram lighted emblem # RP86619. But what I recommend, if possible, is to use a touchless car wash because the problems would show up, if they show up, with car washes with brushes that make contact with the vehicle.
This product has a 90 day warranty so if the finish started to come off in that period it would be covered. view full answer...
The License Plate portion of the DWD Cadillac SRX License Plate, part # 307837 is constructed of stainless steel. The emblems attached to the plate are the same exact OEM emblems used on your SRX. The plate is the standard license plate size, as long as your SRX has the mounting location for a license plate, the plate will indeed fit your vehicle just fine. view full answer...
Yes, the Covercraft car cover part # C15726UB was designed with the hood ornament of your 2002 Mercedes CLK in mind. It would have an area cut out larger to allow it to fit right. view full answer...
Your 2018 Ford Fusion is a Sedan model which I recommend the Curt Trailer Hitch Receiver Item # C12091.
This hitch has a 1-1/4" receiver tube openings with a 350lb tongue weight rating and a 3500lb trailer weight rating. The hitch pin hole is a 1/2" in diameter and does not come with pin and clips. Most bike racks come with pin and clips or anti rattle devices however; if you were planning on pulling trailer you would need Curt Class I and II Pin and Clip Item # F-4.
If your vehicle was... view full answer...
If your Toyota Tacoma Has front parking sensors like many do the Westin Bull Bar part # 31-6005 is likely to interfere. As far as the Dynamic Radar Cruise Sensor most of those will be behind the Toyota emblem in the grill and as you can see in the included photo would not be interfered with.
I understand the concern with safety I just think people like what they like and want to make their vehicle their own. Just like lifting a Jeep Wrangler 6" doesn't at all make it safer or have a lower... view full answer...
For a 1999 motorhome built on an E-450 chassis the brake controller connector is typically located behind the emergency brake pedal, where the floor board, kick panel, and firewall all meet. The connector should be brown. The correct adapter to use then would be the part # 3035-P.
For a brake controller I would recommend the Prodigy P3 Brake Controller part # 90195. This is our best selling brake controller because of how well it works and how easy it is to setup. This is a proportional... view full answer...
The best trailer hitch we offer for your 2002 Pontiac Grand Prix SE Sedan is the Curt Class II hitch part # C12199 which has the highest capacity of all of the hitches we offer, is made in the USA, and will only have the hitch opening hang down below for a more concealed look.
Then for trailer wiring you'd want the Tekonsha kit part # 18252 for a 4-way. Then for a ball mount you'd want Curt ball mount part # C45520 and for a hitch ball either # C40018 for a 2 inch ball or part # C40001... view full answer...
From my research on the 2011 Honda Pilot, the backup camera is located above the center of the rear license plate below the Honda emblem. I called my contact at Kuat, and he told me that the measurement of the hitch pin hole to the tallest part with only two trays on the rack (when folded) on the Kuat NV 2.0 Base Bike Rack # BA22B-BA02B is 24-3/4 inches. While I cannot confirm with certainty if the folded NV 2.0 would block your camera, I recommend measuring the pinhole to the camera location... view full answer...
Go To Results